Fibre plaster NAKS FKK

KIUDKROHV NAKS FKK
FIBRE PLASTER NAKS FKK
REINFORCED, PLASTIC PLASTER MIX
 
 
Based on cement, fine grain sieved sand and plasticisers, containing synthetic filbre.
Colour grey.
Used for plastering porous concrete, weak and problematic backgrounds in interior and exterior conditions. Using fibre plaster lessens the formation of microcracks in a layer of plaster to the minimum. Also, the possibility of setting cracks lessens. Add water 22–24%. The mix is applied with a trowel or a mortar gun. It is recommended to use a float made of wood, cork or other material. Layer thickness when covering large areas is 4–12 mm, at partial plastering 30 mm. The first coat has to dry for 24 hours before applying the second coat. The background, plaster and room temperature must be above +1 °C. After the final setting the mix is heat- and cold-resistant.
 
Product coverage: 6–7 kg/m2 at 5 mm thickness.
Grain size is >1 mm.
Package: 25 kg
 
Category:

Description

KIUDKROHV NAKS FKK
REINFORCED FIBROUS PLASTIC PLASTER MIX NAKS FKK
 
Used for interior and exterior application.
For plastering weak surfaces.
For plastering porous concrete walls.
For plastering areas where a high resistance in needed.
 
Using reinforced fibrous plaster mix lessens the formation of micro cracks in a layer of plaster to a minimum.
The possibility of formation of settlement cracks is reduced.
 
COMPOSITION
Quartz sand, Portland cement, synthetic fibre, polymers and plasticisers.
 
BACKGROUND
All mineral surfaces are suitable.
The surface must be clean, hard and dust free. It is recommended to remove loose paint, grease, dust and other substances that impair adhesion.
 
PREPARATIONS
Pour the necessary amount of mix into the mixing bowl.
Add water 22-24% (5.5-6 litres per 25 kg bag).
Mix carefully until thoroughly wet.
Working time of ready-mixed plaster is 6 hours.
 
PLASTERING
It is recommended to wet very dry and porous surfaces beforehand.
The plaster mix is applied to a wall using a trowel or sprayed with a mortar gun.
Applied plaster mix is allowed to set and smoothed with a float made of cork, wood or other material.
Layer thickness when covering large areas is 4-12 mm, in case of partial plastering up to 30 mm.
 
PRODUCT COVERAGE
6-7 kg/m2 at 5 mm thickness
 
SETTING
The setting time of one layer depends on the layer thickness, air humidity and temperature.
It is recommended to let the previous layer dry for 24 hours before applying the next one.
Hardened surfaces are easy to treat with plaster or paint.
 
RESTRICTIONS
The temperature of surface, plaster and air must be above +1 °C.
Plaster mix is not suitable for applying to greasy or oily surfaces.
 
STORAGE
Plaster mix bags are to be stored in dry conditions.
Storage time is 1 year.